HVAC sheet metal work. Cut steel for body work. unit uses only compressed air
no exotic gases needed. Cut steel for body work, HVAC sheet metal work, metal art. The unit uses only compressed air --no exotic gases needed-- and this makes it one of the safest and easiest ways to cut metal. 36 Amp for up to 3/8" thick cutting capacity. 230V, No-Load Voltage 200V. Single Phase / Current Range: 15-30A. Arc Pilot Feature with 2 second delay. 1-Year Warranty. Dual input voltage allows either 115 or 230 VAC. Starts without high-frequency - will not interfere with controls or computers. Pilot Arc Controller increases cutting capabilities & speeds. Postflow cooling circuit extends life of consumables and torch.

Welds 22 gauge up to 1/2 inch material in a single pass. Seven-tap voltage control allows for a smooth easy-to-control arc. Infinite wire feed speed control for precise adjustment of penetration and weld bead shape. Comes complete with 200 amp gun and built-in running gear/cylinder rack. Hinged door for easy access to wire drive system for spool and drive roll changes. Plasma Cutter, Input Voltage 115 VAC, Open Circuit Voltage 325 VDC, Input Current 20 Amps, Rated Output 12 Amps @ 110 VDC, Duty Cycle 35 Percentage, Overall Height 16 Inches, Overall Depth 16 Inches, Overall Width 8 1/2 Inches, Single Phase, With Built In Compressor. Ideal for shops with mild steel, aluminum, stainless steel and all conductive material. Cuts cleanly w/o overheating and warping surrounding metal.